#define uchar unsigned char
#define uint unsigned int
#define k1 P3_7 //k1功能键
#define k2 P3_6 //k2数值调整键
#define bjh P3_1 //定值输出
#define sx P0_2 //报警值输出（声音）
#define csbout P2_7 //超声波发送
#define csbint P3_5 //超声波接收
uchar ec,cls;cs;xl,mq,xm0,xm1,xm2,sec20,sec,sec1,buffer[3],BitCounter,temp,Number[8]={1,2,3,4,5,6,7,8};
uchar temp1,convert[10]={0x81,0xED,0xA2,0xA8,0xCC,0x98,0x90,0xAD,0x80,0x88};//0~9段码
uint zzz,dz,zzbl,i,jsz,yzsj,kk,s,ss;
static uchar bdata ke,kw; //可位寻址的状态寄存器
float csbc,wdz;
sbit LED1 = P3^4; //数码管位驱动
sbit LED2 = P3^2; //数码管位驱动
sbit LED3 = P3^3; //数码管位驱动
sbit k11=ke^0;
sbit k12=ke^1;
sbit k22=ke^2;
sbit k21=ke^3;
sbit b=ke^4;
sbit c=ke^5;
sbit d=ke^6;
sbit e=ke^7;
sbit w=kw^0;
sbit zj1=kw^1;
sbit zj2=kw^2;
上面居然还有ke^0口
怎么发表后没有回车？
[此贴子已经被作者于2012-5-16 13:09:06编辑过]
| 欢迎光临 (http://www.51hei.com/bbs/) |
Powered by Discuz! X3.1 |