标题: Symbol Putchar multiply defined 重复定义问题,大佬帮忙看下 [打印本页]

作者: 121312    时间: 2019-9-29 09:14
标题: Symbol Putchar multiply defined 重复定义问题,大佬帮忙看下
USART.c文件
#include "stm32f10x_rcc.h"   
#include "stm32f10x_gpio.h"   
#include "stm32f10x_usart.h"   
#include "stm32f10x_crc.h"  
#include "system_stm32f10x.h"   
#include "stdio.h"  
#include "USART.h"  

void RCC_Configuration(void)      
{      
  RCC_APB2PeriphClockCmd(RCC_APB2Periph_USART1|RCC_APB2Periph_GPIOA|RCC_APB2Periph_AFIO|RCC_APB2Periph_GPIOB,ENABLE);      
}     

void GPIO_Configuration(void)      
{      
  GPIO_InitTypeDef GPIO_InitStructure;           
  GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;   
  GPIO_InitStructure.GPIO_Pin = GPIO_Pin_9;               
  GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP;           
  GPIO_Init(GPIOA, &GPIO_InitStructure);                    
  GPIO_InitStructure.GPIO_Pin = GPIO_Pin_10;           
  GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IPU;        
  GPIO_Init(GPIOA, &GPIO_InitStructure);                       
  GPIO_InitStructure.GPIO_Pin = GPIO_Pin_5;  
  GPIO_InitStructure.GPIO_Mode = GPIO_Mode_Out_PP;   
  GPIO_Init(GPIOB, &GPIO_InitStructure);     
}  
void USART_Configuration(void)
{        
    USART_InitTypeDef USART_InitStructure;                  
    USART_InitStructure.USART_BaudRate = 9600;                    
    USART_InitStructure.USART_WordLength = USART_WordLength_8b;//8 bit  
    USART_InitStructure.USART_StopBits = USART_StopBits_1;     //1 stop  bit
    USART_InitStructure.USART_Parity = USART_Parity_No;       //No parity check  
    USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None; ///Innumerable data flow control
    USART_InitStructure.USART_Mode = USART_Mode_Rx | USART_Mode_Tx;   
    USART_Init(USART1,&USART_InitStructure);                    
    USART_Cmd(USART1,ENABLE);   
}  
void delay_ms(u16 time)      
{      
  u16 i=0;      
  while(time--)      
  {      
    i=12000;      
    while(i--);      
  }      
}   
int Putchar(int c)                                             
{   
    if (c == '\n'){putchar('\r');}                                
    USART_SendData(USART1,c);                                 

]326]Q_D8}538E`KH8N2.png (74.26 KB, 下载次数: 55)

]326]Q_D8}538E`KH8N2.png





欢迎光临 (http://www.51hei.com/bbs/) Powered by Discuz! X3.1