Arduino esp8266 blinker温湿度监控源码 -

#define BLINKER_WIFI
#include <Blinker.h>
#include <DHT.h>
char auth[] = "20ce32208396"; //上一步中在app中获取到的Secret Key（新建设备的秘钥）
char ssid[] = "PIG"; //你的WiFi热点名称
char pswd[] = "Zq128hw923"; //你的WiFi密码
BlinkerNumber HUMI("humi");
BlinkerNumber TEMP("temp");
#define DHTPIN 5 //温湿度接的是GPIO5端口
#define DHTTYPE DHT11 // DHT 11
//#define DHTTYPE DHT22 // DHT 22 (AM2302), AM2321
//#define DHTTYPE DHT21 // DHT 21 (AM2301)
DHT dht(DHTPIN, DHTTYPE);
float humi_read = 0, temp_read = 0;
void heartbeat()
{
//反馈温度数据
HUMI.print(humi_read);
//设置ui组件图标和颜色
HUMI.icon("fas fa-thermometer-2");
HUMI.color("#fddb10");
//反馈湿度数据
TEMP.print(temp_read);
TEMP.icon("fas fa-heart");
HUMI.color("#fddb01");
}
void dataStorage()
{
Blinker.dataStorage("temp",temp_read);
Blinker.dataStorage("humi",humi_read);
}
void setup()
{
Serial.begin(115200);
pinMode(PIR_sensor,INPUT);
BLINKER_DEBUG.stream(Serial);
BLINKER_DEBUG.debugAll();
pinMode(LED_BUILTIN, OUTPUT);
digitalWrite(LED_BUILTIN, LOW);
Blinker.begin(auth, ssid, pswd);
Blinker.attachHeartbeat(heartbeat);
Blinker.attachDataStorage(dataStorage);
dht.begin();
}
void loop()
{
Blinker.run();
float h = dht.readHumidity();
float t = dht.readTemperature();
if (isnan(h) || isnan(t))
{
BLINKER_LOG("Failed to read from DHT sensor!");
}
else
{
BLINKER_LOG("Humidity: ", h, " %");
BLINKER_LOG("Temperature: ", t, " *C");
humi_read = h;
temp_read = t;
}
if (t > 20)
{
Blinker.wechat("Title:机房温度","state:temperature high" ,"Message:机房温度过高");
Blinker.sms("机房温度过高！");
}
Blinker.delay(2000);
}

复制代码