pic18 configuration settings---MCC编译器 -

标题: pic18 configuration settings---MCC编译器 [打印本页]

作者: 51黑芯片 时间: 2016-1-16 23:47
标题: pic18 configuration settings---MCC编译器

//-----------------------------------------------
// PIC18 MCC PIC18F6622 CONFIG BITS  1=OFF
//CONFIG1H  禁止振荡器切换，禁止故障保护时钟，HS振荡器
//CONFIG2L　欠压复位电压最大值，禁止欠压复位，禁止上电延时
//CONFIG2H  关看门狗及喂狗时间　
//CONFIG3H 使能MCLR，高功耗TIMER1，CCP2与RC1复用
//CONFIG4L 后台调试关，扩展指令开,BOOT引导区2K，使能单电源,堆栈溢出复位
//CONFIG5L BLOCK0-3代码不保护
//CONFIG5H EEPROM&引导区　代码不受保护
//CONFIG6L BLOCK0-3 不受写保护
//CONFIG6H  数据EEPROM　引导区　配置寄存器不保护
//CONFIG7L 禁止其它块对BLOCK0-3执行表读操作
//CONFIG7H 禁止其它块对引导区（000000-0007FFh）执行表读操作
//-----------------------------------------------
#pragma config  IESO  = OFF,  FCMEN = OFF , OSC = HS
#pragma config  BORV  = 0  ,  BOREN = OFF , PWRT = OFF
#pragma config  WDT = OFF,  WDTPS = 128
#pragma config  MCLRE = ON , LPT1OSC = ON  , CCP2MX = PORTC
#pragma config DEBUG = OFF,  BBSIZ = BB2K, XINST  = ON ,  LVP = ON , STVREN = ON
#pragma config  CP0 = OFF,  CP1    = OFF , CP2 = OFF,  CP3 = OFF
#pragma config CPD = OFF,  CPB    = OFF
#pragma config  WRT0  = OFF,  WRT1 = OFF , WRT2 = OFF,  WRT3  = OFF
#pragma config WRTD  = OFF,  WRTB = OFF , WRTC = OFF
#pragma config  EBTR0 = ON ,  EBTR1 = ON  , EBTR2  = ON
#pragma config EBTRB = OFF

欢迎光临 (http://www.51hei.com/bbs/)