标题:
10秒秒表 精确到0.1 proteus仿真
[打印本页]
作者:
gwx
时间:
2017-3-3 15:47
标题:
10秒秒表 精确到0.1 proteus仿真
10秒秒表 精确到0.1
用proteus仿真
带源文件
0.png
(62.22 KB, 下载次数: 76)
下载附件
2017-3-3 21:55 上传
仿真工程文件下载:
秒表.zip
(55.81 KB, 下载次数: 50)
2017-3-3 15:47 上传
点击文件名下载附件
秒表
下载积分: 黑币 -5
源程序:
/* 名称:10s 的秒表
说明:首次按键计时开始,再次按键暂停,第三次按键清零。
*/
#include<reg51.h>
#define uchar unsigned char
#define uint unsigned int
sbit K1=P3^7;
uchar
i,Second_Counts,Key_Flag_Idx;
bit Key_State;
uchar
DSY_CODE[]={0x3f,0x06,0x5b,0x4f,0x66,0x6d,0x7d,0x07,0x7f,0x6f};
//延时
void DelayMS(uint ms)
{
uchar t;
while(ms--) for(t=0;t<120;t++);
}
//处理按键事件
void Key_Event_Handle()
{
if(Key_State==0)
{
Key_Flag_Idx=(Key_Flag_Idx+1)%3;
switch(Key_Flag_Idx)
{
case 1: EA=1;ET0=1;TR0=1;break;
case 2: EA=0;ET0=0;TR0=0;break;
case 0: P0=0x3f;P2=0x3f;i=0;Second_Counts=0;
}
}
}
//主程序
void main()
{
P0=0x3f; //显示 00
P2=0x3f;
i=0;
Second_Counts=0;
Key_Flag_Idx=0; //按键次数(取值 0,1,2,3)
Key_State=1; //按键状态
TMOD=0x01; //定时器 0 方式 1
TH0=(65536-50000)/256; //定时器 0:15ms
TL0=(65536-50000)%256;
while(1)
{
if(Key_State!=K1)
{
DelayMS(10);
Key_State=K1;
Key_Event_Handle();
}
}
}
//T0 中断函数
void DSY_Refresh() interrupt 1
{
TH0=(65536-50000)/256; //恢复定时器 0 初值
TL0=(65536-50000)%256;
if(++i==2) //50ms*2=0.1s 转换状态
{
i=0;
Second_Counts++;
P0=DSY_CODE[Second_Counts/10];
P2=DSY_CODE[Second_Counts%10];
if(Second_Counts==100) Second_Counts=0; //满 100(10s)后显示 00
}
}
复制代码
欢迎光临 (http://www.51hei.com/bbs/)
Powered by Discuz! X3.1