求使用光电编码器的程序，用1602显示 -

标题: 求使用光电编码器的程序，用1602显示 [打印本页]

作者: huangnima 时间: 2017-8-4 11:48
标题: 求使用光电编码器的程序，用1602显示
求使用光电编码器的程序，用1602显示转速

作者: huangnima 时间: 2017-8-4 15:20
只顶自顶自顶

作者: 天12 时间: 2018-9-13 11:02
将A或B线连接到INT0,利用外部中断0计数脉冲数，再利用定时器定时1秒后读取计数，并计算对应角度，最后由LCD显示所得转速
#include<reg52.h>
typedef unsigned int u16;
typedef unsigned char u8;
#define DATA P0
sbit rs = P3^5;
sbit rw = P3^6;
sbit en = P3^4;
sbit du = P2^6;
sbit we = P2^7;
sbit P1_0=P1^0;

u8 count;
u16 z,num,n;
void delay(u16 z)
{
u16 x,y;
for(x=z;x>0;x--)
   for(y=114;y>0;y--);
}
void write_cmd(u8 cmd)
{
rs = 0;
rw = 0;
DATA = cmd;
delay(5);
en = 1;
delay(5);
en = 0;
}
void write_data(u8 dat)
{
rs = 1;
rw = 0;
DATA = dat;
delay(5);
en = 1;
delay(5);
en = 0;
}
void write_sfm(u8 add,u16 date)
{
u8 bai,shi,ge;
bai = (date%1000)/100;
shi = (date%100)/10;
ge  = date%10;
write_cmd(0x80+add);
write_data(0x30+bai);
write_data(0x30+shi);
write_data(0x30+ge);
}
void lcd_init(void)
{
du = 0;
we = 0;
write_cmd(0x02);
write_cmd(0x06);
write_cmd(0x0c);
write_cmd(0x38);
write_cmd(0x01);
write_cmd(0x80+9);
write_data(0xdf);

EA  = 1;
IT0 = 1;
EX0 = 1;
//  PX0 = 1;
TMOD = 0x01;
TH0 = 0x4b;
TL0 = 0xfd;
ET0 = 1;
TR0 = 1;
}

int main(void)
{
rw = 0;
rs = 0;
en = 0;
lcd_init();
while(1)
{
   P1_0=1;
}
}

void int0() interrupt 0
{
num++;

}
void timer0() interrupt 1
{
TH0=0x4b;
TL0=0xfd;
count++;
if(count==20) //定时1秒
{
   P1_0 = 0;
   n = num*0.18;  //1秒所转的角度这个编码器的分辨率为2000P/R
   write_sfm(5,n);
   delay(20);
   num=0;
   count = 0;
}
}

欢迎光临 (http://www.51hei.com/bbs/)