|
给51黑电子论坛的朋友们分享一个用51单片机0~9999计数器程序和proteus仿真,下面是原理图:
源程序:
- /********************************************************************
- 天马电子
- *********************************************************************/
- #include <reg52.h>
- #define uchar unsigned char
- #define uint unsigned int
- uchar duan[10]={0xc0,0Xf9,0xa4,0xb0,0x99,0x92,0x82,0xf8,0x80,0x90}; //所需的段的位码
- //uchar wei[4]={0XEf,0XDf,0XBf,0X7f}; //位的控制端 (开发板)
- uchar wei[4]={0X80,0X40,0X20,0X10}; //位的控制端 (仿真)
- uint z,x,c,v, date; //定义数据类型
- uint dispcount=0;
- /******************************************************************
- 延时函数
- ******************************************************************/
- void delay(uchar t)
- {
- uchar i,j;
- for(i=0;i<t;i++)
- {
- for(j=13;j>0;j--);
- { ;
- }
- }
- }
- /**********************************************************************
- 数码管动态扫描
- *********************************************************************/
- void xianshi()
- {
- /*****************数据转换*****************************/
- z=date/1000; //求千位
- x=date%1000/100; //求百位
- c=date%100/10; //求十位
- v=date%10; //求个位
- P2=wei[0];
- P0=duan[z];
- delay(50);
- P2=wei[1];
- P0=duan[x];
- delay(50);
- P2=wei[2];
- P0=duan[c];
- delay(50);
- P2=wei[3];
- P0=duan[v];
- delay(50);
-
- }
- /*************************************************************************
- 主函数
- **************************************************************************/
- void ExtInt0() interrupt 0 //中断服务程序
- {
- dispcount++; //每按一次中断按键,计数加一
- if (dispcount==9999) //计数范围0-9999
- {dispcount=0;}
- }
- /*************************************************************************
- 主函数
- **************************************************************************/
- void main()
- {
- TCON=0x01; //中断设置
- IE=0x81;
- while(1)
- {
- date=dispcount;
- xianshi();
- }
- }
-
复制代码
仿真工程文件及所有完整程序等资料下载地址(压缩包一共有45个单片机仿真,全部下载后找到这个项目035即可):
http://www.51hei.com/bbs/dpj-56298-1.html
|
|